Trap Barriers: These are motorized and manual barriers made of toothed claws that allow one-way passage. In manual trap barriers, the teeth are angled at 45 degrees towards the side where vehicle passage is to be prevented. Vehicles approaching from the rear can pass freely, while vehicles approaching from the opposite direction cannot pass unless there is a motor, arm, etc. Motorized trap barriers are equipped with a motor or hydraulic unit. The motor or hydraulic unit lowers the teeth of the barrier, allowing passage in both directions. Manual trap barriers do not contain any electric motor or hydraulic system. These trap systems provide one-way entry or exit. By integrating an arm, you can also provide two-way traffic flow. Because they do not contain any electronic materials, they are long-lasting. Since they are custom-made models to meet specific needs, they are designed entirely according to the user's wishes. Our trap barriers generally use a width of 35 cm, a tooth height of 10 cm, and a base plate thickness of 10 mm. Our automatic motorized vehicle barriers, designed for areas where very heavy vehicles will pass, have adjustable height plates. These barrier models contain a motor and electronic components. These trap systems operate with integrated remote controls, buttons, or any type of access control unit. In motorized vehicle barriers, the safety of your vehicle is ensured by photocells located at both ends of the barrier. Vehicle barriers allow free passage in one direction only. For vehicles approaching from the other direction, a remote control or access control unit is required to lower the barrier teeth. In hydraulic automatic barriers, thanks to the hydraulic unit, when triggered by a remote control, card, or access control unit, the barrier teeth lower via a piston. After vehicles pass, the barrier teeth automatically close or rise again via access control units, preventing further vehicle passage. If desired, the road can be closed to traffic in both directions. Alternatively, one-way free passage is possible, while on the other hand, control is provided by triggers from access control units. Assassination-Type Trap Barriers: The most important factor distinguishing these trap barriers from others is the length of their teeth and the type of material used. This vehicle trap, unlike other trap systems, stops the car by embracing it from front to back, not just the tires. Assassination-type traps are generally suitable for places requiring high security. These trap barriers, like other trap systems, can be made manual, motorized, mechanical, or hydraulic.